Plastic Film Extrusion Machinery Manufacturer-Nanjing Sumino Precision Machinery Co.,Ltd

Common problems and solutions of laminating machine

Common problems and solutions of laminating machine



1. Heating system



(1) Slow heating: the yellow light of the temperature control meter (OUT1) is on, please check the index of the upper ammeter, if the index is not enough, the possibility is: one of the heating zones is burnt out, and one of the heating zone wires is faulty.



(2) No heating: The contactor is broken, the end of the heating line is loose, and the temperature control meter is broken.




2. Inverter alarm

If the input of winding and unwinding diameter is incorrect, the frequency converter will alarm, and the alarm screen in the main operation screen can be reset by pressing Fault.



3. The buffer pendulum is unstable

(1). The input of the winding and unwinding diameter is incorrect, and the measured diameter should be input again.

(2). The potentiometer of the buffer swing rod is shifted, and the solution is: clear the tension setting to zero, and the swing rod is in a vertical state. Adjust the gear of the swing rod potentiometer until the position of the swing rod on the main operation screen displays 50.



4. Electrical failure


When the electrical part fails, please check the input power first, then check the peripheral circuit, and then check the corresponding controller; the frequency converter, PLC, etc. have various protection functions, and there will be no serious failure under normal circumstances.


(1). Inverter failure: When a certain inverter fails, the whole machine will automatically decelerate and stop; check the "Troubleshooting" section of the inverter manual, and take corresponding measures to reset the faulty inverter and restart it.

(2). PLC failure: PLC itself generally rarely fails. When a fault occurs, the "PROG-E" indicator on the right side of the PLC host is always on; check whether the peripheral circuit of the input and output points is short-circuited and reset the PLC working power supply.



Nanjing Sumino Precision Machinery Co., Ltd. is a high-tech enterprise integrating scientific research, production and sales. It has always adhered to the business philosophy of integrity, equality, and customer interests first. In order to better improve the quality of equipment, it has entered a more professional and standardized production track. We have established independent research and development technologies for seven types of equipment, including plastic sheet, casting, biaxial stretching, non-woven non-woven melt-blown cloth, laminating and compounding, recycling granulation environmental protection recycling system and coating machine manufacturing system. center and production department. Provide a full set of professional technical solutions to meet the special needs of each customer. Among them, regarding the extrusion composite manufacturing system, that is, the coating machine, the following production lines are available for customization: PE double/three-layer co-extrusion composite production line, LDPE (three-in-one) coating production line, PP, PE, PLA double-sided coating Film lamination production line, aluminum foil high-speed lamination lamination production line, PP spunbond lamination lamination production line, textile interlining lamination lamination production line, hot-melt spray lamination lamination production line, multi-layer extrusion lamination production line, graphene coating lamination production line, carbon fiber Laminating composite production line.